DS 3 Manuals

Peugeot 2008: In the event of a breakdown / Tool kit

Set of tools supplied with the vehicle.

Its content depends on your vehicle's equipment:

  • Temporary puncture repair kit.
  • Spare wheel.

Access to the tools

Depending on version, the tool kit is stored in a bag or in a storage box in the boot.

Peugeot 2008. Tool kit

On the boot carpet or floor

Peugeot 2008. Tool kit

Under the boot carpet or floor

  • Raise the boot floor (depending on version), then the boot carpet by pulling the strap to access the tools.

With temporary puncture repair kit

Peugeot 2008. Tool kit

With spare wheel

Peugeot 2008. Tool kit

Peugeot 2008. Tool kit These tools are specific to the vehicle and may vary according to the level of equipment.

Do not use them for any other purpose.

Peugeot 2008. Tool kit The jack must only be used to change a wheel with a damaged or punctured tyre.

Do not use any jack other than the one supplied with the vehicle.

If the vehicle does not have its original jack, contact a PEUGEOT dealer or a qualified workshop to obtain the one that was intended by the manufacturer.

The jack meets European standards, as defined in the Machinery Directive 2006/42/CE.

The jack does not require any maintenance.

List of tools

Peugeot 2008. Tool kit

  1. Chock to immobilise the vehicle (depending on equipment)
  2. Socket for the wheel security bolts (located in the glove box) (depending on equipment)

    For adapting the wheelbrace to the special ‘security’ bolts.

  3. Removable towing eye

For more information on Towing the vehicle and using the removable towing eye, refer to the corresponding section.

With temporary puncture repair kit

Peugeot 2008. Tool kit

  1. 12  V compressor with a cartridge of sealant and a speed limit sticker

    For temporary repair of a tyre and to adjust the tyre pressure.

For more information about the Temporary puncture repair kit, refer to the corresponding section.

With spare wheel

Peugeot 2008. Tool kit

  1. Wheelbrace

    For removing the wheel trim and the wheel bolts.

  2. Jack with integrated handle

    To raise the vehicle.

  3. Wheel bolt cap remover (depending on equipment)

    For removing the wheel bolt head finishers on alloy wheels.

For more information on the Spare wheel, refer to the corresponding section.

    Running out of fuel (Diesel)

    With Diesel engines, the fuel system must be primed if you run out of fuel. Before starting to prime the system, it is essential to put at least 5 litres of Diesel into the fuel tank...

    Temporary puncture repair kit

    Scan the QR Code on page 3 to view explanatory videos. Made up of a compressor and a sealant cartridge,   it allows you to carry out a temporary repair of the tyre so that you can drive to the nearest garage...

    Other information:

    Peugeot 2008 2019-2024 Owner's Manual: Stop & Start


    The Stop & Start function puts the engine temporarily into standby - STOP mode - during phases when the vehicle is stopped (red lights, queues, etc.). The engine restarts automatically - START mode - as soon as the driver wishes to move off again...

    Peugeot 2008 2019-2024 Owner's Manual: Settings


    Configuring profiles Press Settings to display the main page. Press "Profiles". Select "Profile 1", "Profile 2", "Profile 3” or "Common profile". Press this button to enter a name for the profile using the virtual keypad. Press "OK" to save. Press the back arrow to confirm...

    Categories

    read more

    Copyright © 2024 www.pe2008.net