Peugeot 2008: In the event of a breakdown / Running out of fuel (Diesel)
With Diesel engines, the fuel system must be primed if you run out of fuel.
Before starting to prime the system, it is essential to put at least 5
litres of Diesel into the fuel tank.
For
more information on Refuelling and on Misfuel prevention (Diesel),
refer to the corresponding section.
1.5 BlueHDi engines
- Switch on the ignition (without starting the engine).
- Wait around 1 minute and switch off the ignition.
- Operate the starter motor to start the engine.
If the engine does not start at the first attempt, do not keep trying, but
restart the procedure.
As a safety precaution, before leaving your vehicle to set up and install the
triangle, switch on the hazard warning lamps and put on your high visibility
vest...
Set of tools supplied with the vehicle.
Its content depends on your vehicle's equipment:
Temporary puncture repair kit.
Spare wheel.
Access to the tools
Depending on version, the tool kit is stored in a bag or in a storage box in
the boot...
Other information:
This system manages the duration of use of certain functions, in order to
conserve a sufficient level of charge in the battery with the ignition off.
After switching off the engine, you can still use functions such as the audio
and telematic system, the wipers and the dipped beam headlamps or courtesy lamps,
for a combined duration of approximately 40 minutes...
The system prevents a rear door from being opened using its interior handle.
The red control is located on the edge of each rear door (marked by a label).
Locking / Unlocking
To lock, turn the red control as far as it will go using the
integral key:
To the right on the left-hand rear door...