Refer to the General recommendations on the use of driving and manoeuvring aids.
Take a break in case of feeling tired or at least every 2 hours.
The function comprises the "Driver Attention Alert" system combined with the "Driver Attention Alert by camera" system.
These systems are in no way designed to keep the driver awake or to prevent the driver from falling asleep at the wheel.
It is the driver’s responsibility to stop if feeling tired.
Activation / Deactivation
It is set via the Driving / Vehicle touch screen menu.
The state of the system stays in the memory when the ignition is switched off.
Driver Attention Alert
The system triggers an alert as soon as it detects that the driver has not taken a break after two hours of driving at a speed above 40 mph (65 km/h).
This alert is issued via the display of a message encouraging the driver to take a break, accompanied by an audible signal.
If the driver does not follow this advice, the alert is repeated hourly until the vehicle is stopped.
The system resets itself if one of the following conditions is met:
As soon as the speed of the vehicle drops below 40 mph (65 km/h), the system goes into standby.
The driving time is counted again once the speed is above 40 mph (65 km/h).
Driver Attention Alert by camera
Using a camera placed at the top of the windscreen, the system assesses the driver's level of vigilance, fatigue or distraction by identifying variations in trajectory compared to the lane markings.
This system is particularly suited to fast roads (speed higher than 40 mph (65 km/h)).
At a first-level alert, the driver is warned by the “Take care!” message, accompanied by an audible signal.
After three first-level alerts, the system triggers a further alert with the message "Dangerous driving: take a break", accompanied by a more pronounced audible signal.
In certain driving conditions (poor road surface or strong winds), the system may give alerts independent of the driver's level of vigilance.
The following situations may interfere with the operation of the system or prevent it from working:
This system manages the duration of use of certain functions, in order to conserve a sufficient level of charge in the battery with the ignition off.
After switching off the engine, you can still use functions such as the audio and telematic system, the wipers and the dipped beam headlamps or courtesy lamps, for a combined duration of approximately 40 minutes.
Selecting the mode
A confirmation message is displayed when energy economy mode is entered, and the active functions are placed on standby.
If a telephone call is in progress at the time, it will be maintained for around 10 minutes via the audio system’s hands-free system.