Peugeot 2008: Driving / Cruise control - particular recommendations
For
the safety of everyone, only use the cruise control where the driving conditions
allow running at a constant speed and keeping an adequate safety distance.
Remain vigilant when the cruise control is activated. If you
hold one of the speed setting modification buttons down, a very rapid change in
the speed of your vehicle may occur.
When descending a steep hill, the cruise control system cannot
prevent the vehicle from exceeding the set speed. Brake if necessary to control
the speed of your vehicle.
On steep climbs or when towing, the set speed may not be reached
or maintained.
Exceeding the
programmed speed setting
The speed setting can be exceeded temporarily by pressing the
accelerator pedal (the programmed speed flashes).
To return to the speed setting, release the accelerator pedal (when
this speed is reached again, the display of the speed stops flashing).
Operating limits
Never use the system in the following situations:
- In an urban area with the risk of pedestrians crossing the road.
- In heavy traffic (except versions with the Stop & Go function).
- On winding or steep roads.
- On slippery or flooded roads.
- In poor weather conditions.
- Driving on a speed circuit.
- Driving on a rolling road.
- When using snow chains, non-slip covers or studded tyres.
Refer to the General recommendations on the use of driving and manoeuvring
aids.
This system prevents the vehicle
from exceeding the speed programmed by the driver (speed setting)...
Refer to the General recommendations on the use of driving and manoeuvring
aids and to Cruise control - particular recommendations.
This system automatically keeps
the vehicle’s speed at the cruise value programmed by the driver (speed
setting), without using the accelerator pedal...
Other information:
Hill Assist Descent ControlFixed.
(grey)
The function has been activated, but is currently paused because the speed is
too high.
Reduce the vehicle speed to below 19 mph (30 km/h).
Fixed.
The system has been activated, but the conditions for regulation are not met
(gradient, speed too high, gear engaged)...
Selective unlocking (driver’s
door, boot) is configured in the Driving/Vehicle touch screen menu.
Selective unlocking is deactivated by default.
Complete unlocking
The vehicle (doors and boot) unlocks:
Either automatically as the driver approaches in zone C, if the
automatic functions are activated...